Health and Carcinogenic Risk Assessment of Exposure to by-Products of Photocatalytic Degradation of Toluene in a Spouted Bed Reactor with Porous and Non-Porous Draft Tube

Document Type : Research Articles

Authors

1 Department of Occupational Health and Safety Engineering, School of Public Health and Safety, Shahid Beheshti University of Medical Sciences, Tehran, Iran.

2 Environmental and Occupational hazard control research center, School of Public Health and Safety, Shahid Beheshti University of Medical Sciences, Tehran, Iran.

3 Department of Mechanical Engineering, Faculty of Engineering, Alzahra University, Tehran, Iran.

Abstract

Objective: This study was performed to assessment the health and carcinogenic risk of exposure to by-products of photocatalytic degradation of toluene in a spouted bed reactor Equipped with porous and non-porous draft tube. Methods: For this purpose, titanium dioxide nanoparticles were used as photocatalysts and UV lamps as radiation sources. Degradation efficiency and CO2 selectivity were compared. By-products were also detected in three spouted bed reactors with and without a porous and non-porous draft tube. Result: The results revealed that the degradation efficiency of toluene in the spouted bed reactor without a draft tube was 30.75%. The insertion of porous and non-porous draft tubes in the spouted bed reactor increased the degradation efficiency up to 54.88% and 47.63%, respectively. Meantime, CO2 selectivity decreased from 100% to 50.8% within 180 min irradiation time in the spouted bed reactor without draft tube, while in the spouted bed reactors with porous and non-porous draft tube maintained at 89.85% and 84.35%, respectively. Toluene and four by-products with carcinogenic and non-carcinogenic risk of 0.002176 and 182.2, respectively, were detected in the spouted bed reactors without draft tube. However, no by-products with carcinogenic risk were found in the spouted bed reactor with porous and non-porous draft tube. Conclusion: photocatalytic degradation of toluene in a spouted bed reactor without a draft tube produces by-products with health and carcinogenic risks. The insertion of a porous and non-porous draft tube in spouted bed reactors provided mineralization more complete than spouted bed reactor without a draft tube by reducing the dead zone and providing appropriate contact between the toluene, photocatalyst, and UV. Therefore, prevent the formation of dangerous and carcinogenic by-products.

Keywords

Main Subjects